EasyManuals Logo

Dranetz PowerGuide 4400 User Manual

Dranetz PowerGuide 4400
277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #224 background imageLoading...
Page #224 background image
C-6
Battery Pack Replacement
Battery Pack Replacement
Introduction
The 4400 contains an easily replaceable internal battery pack. See Appendix D for
ordering information.
WARNING
Replace with Dranetz
NiMH battery pack BP-PX5 only.
ADVERTENCIA
Reemplace con batería Dranetz NiMH BP-PX5 solamente.
AVERTISSEMENT
Remplacer par la batterie Dranetz NiMH BP-PX5 exclusivement.
WARNUNG
Nur mit Dranetz
NiMH BP-PX5 Batteriesatz auswechseln.
NOTE
During normal operation, the battery pack will be slightly warm to the touch.
Procedure
Follow these steps to replace the battery pack.
Continued on next pa
g
Step Action
1 Press the 4400 power button to off.
2 Turn off power to the circuit being measured.
3 Disconnect voltage and current probes from the circuit and the 4400s
rear panel.
4 On the bottom of the 4400, push the tab to release the battery cover.
Refer to the diagram shown on page C-7.
5 Remove the cover.
6 Pull up on removal strap and remove battery pack.
7 Insert the new pack into the compartment making sure to observe
polarity markings.
8 Replace the cover and press down until it latches closed.
9 Discard the old battery pack in accordance with Environmental
Protection Agency (EPA) regulations.
10 Press the 4400 power button to on.
w ww . . co m
information@itm.com1.800.561.8187

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dranetz PowerGuide 4400 and is the answer not in the manual?

Dranetz PowerGuide 4400 Specifications

General IconGeneral
BrandDranetz
ModelPowerGuide 4400
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals