Vigor2960 Series User’s Guide
305
Hello message will be emitted periodically when a tunnel is
idle. Use the value 0 to disable this function. The
recommended value is 30 seconds if enabled.
DPD Timeout
It is the timeout timer. The peer will be declared dead once
no acknowledge message is received after timeout value.
Use the value 0 to disable this function. The recommended
value is 120 seconds if enabled.
If you choose SSL as the Type, you will get the following screen:
Available parameters are listed as follows:
Item Description
Profile
Display the name of the VPN profile.
Enable
Check this box to enable such profile.
Always On
Click Enable to make the profile being always on.
Dial-Out Through
Choose a wan profile to be used by such profile. Then, use
the default WAN IP or specify a WAN Alias IP for VPN
tunnel.
Failover to
Choose a wan profile which will lead the data passing
through other WAN automatically when the selected WAN
interface (in Dial-Out Through) is failover.
Idle Timeout
When Always On is disabled, you have to type the value for
terminating the network connection.
Server IP/Host
Name
Type the IP address or host name of SSL VPN server.
SSL User Name
Type a user name for authentication in SSL VPN connection.
SSL Password
Type a password for authentication in SSL VPN connection.
To Next Page
Loading...
Need help?
General
