Vigor2960 Series User’s Guide
309
Netbios Naming
Packet
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Multicast via VPN
Some programs might send multicast packets via VPN
connection.
Enable – Click this button to let multicast packets pass
through the router.
Disable – This is default setting. Click this button to let
multicast packets be blocked by the router.
RIP via VPN
Enable – Click it to exchange routing information
packets via VPN connection.
Disable – Disable such function. This is default setting.
If you choose IPsec as the Type in Step 1, you will get the following page:
Available parameters are listed as follows:
Item Description
Profile
Display the name of the VPN profile.
Enable
Check this box to enable such profile.
WAN Profile
Choose a WAN profile to be used by such profile.
Local IP/Subnet
Mask
Type the IP address and subnet mask of local host.
Local Next Hop
Specify the gateway for WAN interface. Usually, use the
To Next Page
Loading...
Need help?
General
