Drayton Wiser - Smart Plug LED behaviour

52/57
More on Installation
LED behaviour Radiator Thermostat
Error state
State User Interaction
Left
LED
Centre
LED
Right
LED
Duration
Low battery
Solid for 1 second (Repeated each hour)
Critical battery
Fast ash for 5 seconds (Repeated each minute)
No signal Twist the cap in the + direction to start a boost Fast ash for 5 seconds (Repeated)
No signal Twist the cap in the - direction to start a boost Fast ash for 5 seconds (Repeated)
No network Twist the cap in the + or - direction to start a boost
Solid with fade-out after 2 seconds. In this event, the
radiator thermostat has not joined the Wiser system and
must either join the Heat Hub
R
or be re-installed.
LED behaviour Smart Plug
Normal use
State User Interaction LED
-
Plug into wall socket (when not joined to the Heat
Hub
R
)
1 red ash followed by 3 purple / red ashes followed by 3 blue ashes
- Plug into wall socket (when joined to the Heat Hub
R
) Red ash followed by solid purple for 1 second followed by solid blue for 1 second
Socket ON Press ON/OFF button Solid blue
Socket OFF Press ON/OFF button Off
Join smart plug to the Heat
Hub
R
Press and hold ON/OFF button for 2 seconds
Quick blue ashes. If the smart plug successfully joins the Heat Hub
R
, the LED stops
ashing. If the smart plug fails to join the Heat Hub
R
, after 60 seconds, the quick blue
ashes are followed by 6 slow ashes.
Interrupt Join Mode Press ON/OFF button Quick blue ashes are interrupted and followed by 6 slow blue ashes.
Reset the smart plug and
return to factory settings
Press and hold ON/OFF button for 5 seconds 6 slow blue ashes