Dremel 3D40 FLEX - Initial Setup; Preparing Build Plate

CALIBRATE

position.
JOG MODE


DISPLAYLANGUAGE
Z-AXIS
OFFSET
SOUNDS
DEMO
MODE
FACTORY
RESET
CHECK
FOR UPDATES
BACK
HOME
SETTINGS
LANGUAGE
DISPLAY

Z-AXIS OFFSET – Used to calibrate build plate

SOUNDS󰀨
DEMO MODE󰀨
FACTORY RESET
stored on 3D40 FLEX and return it to factory defaults.
CHECK FOR UPDATES – Tap to check for new

PREHEAT


PURGE

 – Tap to stop or start preheating.
15