FIG. 9
Removal Tool
inside your object or hard to reach.
BEST PRACTICES
1.
2. Ensure your build plate is level before every object.
3. Ensure spool is installed properly and can rotate
freely.
4.
5.
object, clean the build plate, and start your object
the building process.
6.
7.
8.
the build plate or object.
9. Whenever possible, it is best to locate your object
in the center of the build plate. Using the best
orientation for your object is critical. Ensure that
your object is located on the build plate and that
you are using the best orientation for building.
10. For steep overhangs (Less than 45 degree angle) it
11.
object.
12.
13.
length gauge.
MAINTENANCE
UNCLOGGING THE EXTRUDER
Use the unclogging tool to clean the extruder and
1. Wait for extruder to heat up insert the unclog tool
into the extruder intake (top).
2. Clogged debris will be pushed down and will
548
To Next Page
Loading...
Need help?
General
