5.
touchscreen indicates that it is ready to verify that
the bed is level.
6.
the direction, if the level is correct, the extruder will
be repeated.
7. Repeat steps 4-6 for the second position, when you
leveling process.
CONNECTING USB CABLE
1.
position.
2.
3. Open software.
4.
FLEX.
CONNECTING ETHERNET
1.
position.
2.
3.
switch. Ethernet connection should be detected
Ethernet
USB
BUILDING
!
WARNING
OBSERVE ALL PROVIDED
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D40
FLEX.
!
WARNING
DO NOT REACH INSIDE THE
DREMEL 3D40 FLEX WHILE IT
IS IN OPERATION. Contact with Dremel 3D40 FLEX
NOTE: Your Dremel 3D40 FLEX will build test objects
before leaving the factory. These test objects may have
been made with a dierent lament color than you are
using. Therefore, a small amount of lament may be
remaining in the extruder. The start of your rst object
may have some of this lament color until it transitions
over to your lament color.
You have several options when building on your 3D40
FLEX:
1) On-Printer Storage
545
To Next Page
Loading...
