MAINTENANCE AND SERVICE
Problem Corrective Action
is failing to build.
3D40 FLEX. Cancel your object, clear
object.
PLA is not extruding or sticking to the
build tape properly.
This can be caused by the build
extruder head.
the extruder head and ensure a better
object quality. Cancel your object, clear
and restart the object.
object started.
seconds, and turn power switch on.
away during cleaning and results in
surface.
A layer of your object did not stick
no support selected.
with supports when necessary.
Part only built halfway.
Clogged extruder.
Stringy or fraying plastic layers on
steep overhangs.
Object overhangs are too far apart or
too steep (<45 degree angle).
network.
Reposition 3D40 FLEX to be closer to
your router.
Connect to network with Ethernet.
network.
Reposition 3D40 FLEX to be closer to
your router.
Network password incorrect. Re-enter your password or verify your
password with your network owner.
29
To Next Page
Loading...
