MAINTENANCE AND SERVICE
Problem Corrective Action
is failing to build.
3D40 FLEX. Cancel your object, clear
object.
PLA is not extruding or sticking to the
build tape properly.
This can be caused by the build
extruder head.
the extruder head and ensure a better
object quality. Cancel your object, clear
and restart the object.
object started.
seconds, and turn power switch on.
away during cleaning and results in
surface.
A layer of your object did not stick
no support selected.
with supports when necessary.
Part only built halfway.
Clogged extruder.
Stringy or fraying plastic layers on
steep overhangs.
Object overhangs are too far apart or
too steep (<45 degree angle).
network.
Reposition 3D40 FLEX to be closer to
your router.
Connect to network with Ethernet.
network.
Reposition 3D40 FLEX to be closer to
your router.
Network password incorrect. Re-enter your password or verify your
password with your network owner.
UPDATING FIRMWARE MANUALLY
If your 3D40 FLEX is not connected to a network, you
1.
support and download the latest 3D40 FLEX
2.
3.
4.
5. Turn on your 3D40 FLEX and it should
6.
update.
CLEANING THE EXTERIOR
Clear the outer surfaces of any debris that is visible.
FLEX.
CLEANING THE EXTRUDER TIP
!
WARNING
USE EXTRA CARE NOT TO
DAMAGE THE EXTRUDER TIP
WHEN CLEARING DEBRIS. DREMEL 3D40 FLEX WILL
NOT WORK PROPERLY WITH DAMAGED EXTRUDER
!
WARNING
DO NOT TOUCH THE EXTRUDER
TIP DURING DREMEL 3D40 FLEX
OPERATION OR UNTIL IT HAS COOLED DOWN TO
Contact with the extruder tip during or
heated.
CLEANING THE TOUCH SCREEN
Wipe the touch screen with the soft, lint-free cloth. Do
not spray cleaners on the touch screen.
28
To Next Page
Loading...
Need help?
General
