INITIAL SETUP
PREPARING BUILD PLATFORM
!
WARNING
DO NOT DROP THE BUILD
PLATFORM. TEMPERED GLASS
PLATE MAY BREAK AND RESULT IN PERSONAL
INJURY.
!
WARNING
DO NOT REMOVE TEMPERED
GLASS PLATE FROM PLASTIC
HOLDER. CONTACT WITH TEMPERED GLASS PLATE
EDGE MAY RESULT IN PERSONAL INJURY.
!
BEFORE EVERY BUILD MAKE
SURE THAT THE FLEXIBLE
BUILD PLATE IS COVERED WITH DREMEL
SPECIFIED BUILD TAPE. USE OF IMPROPER BUILD
1.
build plate, and the build plate holder. The build
2.
3.
B
B
A
A
FIG. 3
FIG. 4
Flexible Build
Flexible Build
Plate
Build Plate
Holder
Notch
Handle
Handle
Notch
Build Tape
4.
the build plate holder by sliding it backwards at an
slide under the notches at the back of the build
at the front to hold it in place.
TIP:
already installed in the printer. In general, once the
build plate holder is installed in the printer you do
5.
6.
clips.
Clip
LIFT
PRESS
Clip Clip
542
To Next Page
Loading...
Need help?
General
