Dremel 3D40 FLEX - Page 543

3. 

󰀨





B
B
A
A
FIG. 3
FIG. 4
Flexible Build
Flexible Build
Plate
Build Plate
Holder
Notch

Handle
Handle
Notch
Build Tape
4. 
the build plate holder by sliding it backwards at an

slide under the notches at the back of the build


at the front to hold it in place.
TIP:

already installed in the printer. In general, once the
build plate holder is installed in the printer you do


5. 

󰀨

6. 
clips.

Clip
LIFT
PRESS
Clip Clip
543