Dremel 3D40 FLEX - Used Symbols; FCC Compliance; Information on Intellectual Property; Functional Description and Specifications

USED SYMBOLS
Symbol Name 
Explanation
!
WARNING

Alerts user to warning



Alerts user to read

V Volts Voltage
A  Current)
Hz Hertz
Frequency, cycles per
second
Ø 
o 󰀨
Alternating current
Type or a characteristic
of current
Hot surface


burn. Allow to cool
before servicing.

build plate holder


function of cardiac

FCC COMPLIANCE





generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance


guarantee that interference will not occur in a particular

interference to radio or television reception, which can
󰀨
user is encouraged to try to correct the interference by

• Reorient or relocate the receiving antenna.
• 
and receiver.
• 
󰀨
connected.
• Consult the dealer or an experienced radio/TV
technician for help.




INFORMATION ON INTELLECTUAL
PROPERTY




is your responsibility to ensure that you do not infringe
any third party intellectual property rights or violate any
applicable laws or regulations, such as U.S. or foreign


property rights owned by third parties without such



whole or in part) of any object not created by you, to


you did not create. It is your responsibility to obtain


cannot be obtained, you should not 3D print such






Instructions, you do so at your own risk. Using the

intellectual property rights owned by third parties could



FUNCTIONAL DESCRIPTION AND
SPECIFICATIONS
BUILDING
Extruder: Single extrusion

Operating Interface: 3.5” full color IPS touch screen






WEIGHT & DIMENSIONS
Weight (without spool): 16kg (35lbs)


FILAMENT

FILAMENT STORAGE



SOFTWARE

Digilab 3D Slicing software for Windows and Mac


SUPPORTED OPERATING SYSTEMS
• Apple
®
Mac
®
OS
®
X v10.9 or later (Mavericks)
• Microsoft
®
Windows
®
8.1
• Microsoft
®
Windows
®
7 SP1
MINIMUM SYSTEM SPECIFICATIONS
• CPU: 64-bit processor (32-bit not supported)
• 
• 
• 
Microsoft
®
Direct3D
®
11 capable graphics card or
higher
• 

3D40 FLEX input rating: 100-240V, 47-60Hz, 0.8A-1.8A
OPERATING ENVIRONMENT

Level workspace

16” (406mm)
20.25” (515mm) 15.5” (394mm)
8” (203mm)
8” (203mm)8” (203mm)
14” (356mm)
WALL
526