Dremel 3D40 FLEX - Touch Screen; Build & Model Selection; Build Menu

GETTING READY TO BUILD
!
WARNING
OBSERVE ALL PROVIDED
WARNINGS AND SAFETY
INSTRUCTIONS WHEN USING THE DREMEL 3D40
FLEX. 

!
WARNING
DO NOT TOUCH THE EXTRUDER
TIP DURING OPERATION OR

Contact with the extruder tip during or after


!
WARNING
USE ONLY DREMEL FILAMENT.


damage.
!
WARNING
DO NOT PULL THE FILAMENT
OUT. 
extruder.

1. 


tip will begin to heat.
2. 
Lid for better access to extruder.
3. 

touchscreen.
4. 



Open

Filament Filament Guide Tube
Spool Holder
FIG. 2
Guide Tube Filament Filament Guide Extruder intake
5. 
place spool on spool holder, replace spool door by
aligning locking tabs and rotating clockwise, see


6. 

7. 

tube into extruder intake until extruder feeds

8. 

NOTE: Your Dremel 3D40 FLEX was tested by
building objects before leaving the factory. These
test objects may have been made with a dierent
lament color than you are using. Therefore, a
small amount of lament may be remaining in the
extruder.
18