2.
Lid for better access to extruder.
3.
touchscreen.
4.
Open
Filament Filament Guide Tube
Spool Holder
FIG. 2
Guide Tube Filament Filament Guide Extruder intake
5.
place spool on spool holder, replace spool door by
aligning locking tabs and rotating clockwise, see
6.
7.
tube into extruder intake until extruder feeds
8.
NOTE: Your Dremel 3D40 FLEX was tested by
building objects before leaving the factory. These
test objects may have been made with a dierent
lament color than you are using. Therefore, a
small amount of lament may be remaining in the
extruder.
9.
touching hot extruder tip. If necessary, carefully
pliers.
!
WARNING
USE EXTRA CARE NOT TO
DAMAGE THE EXTRUDER TIP
WHEN CLEARING DEBRIS. DREMEL 3D40 FLEX WILL
NOT WORK PROPERLY WITH A DAMAGED
10. Close 3D40 FLEX lid and door.
19
To Next Page
Loading...
