54
NOTES
• Programming at installation may be subordinate to other UL
requirements for the intended application.
• Cross zones have the ability to individually protect the
intended area (e.g., motion detectors, which overlap).
• Cross zoning is not recommended for line security Installa-
tions nor is it to be implemented on exit / entry zones.
• There is a communication delay of 30 seconds in this control
panel. It can be removed, or it can be increased up to 45 sec-
onds at the option of the end user by consulting with the
Installer.
• Do not duplicate any reporting codes. This applies for all
communication formats other than SIA sending automatic
programmed reporting codes.
• The control unit must be installed with a local sounding
device and an off-premise transmission for SIA communica-
tion format.
• For ULC Listed Fire Monitoring Installations & module
requirements, please refer to the ULC Installation Informa-
tion sheet, part# 29002157.
• Use a CSA/cUL transformer, hardwired.
• All tamper circuits may be connected to the same zone.
Use ULC-LA for AC Power indication.
To Next Page
Loading...
