4
Enclosures/Cabinets
The PC1616/PC1832/PC1864 main board can be installed in the
following metal enclosures/cabinets:
Accessories can be installed in separate metal cabinets as follows:
All cabinets are provided with means for installing tamper protec-
tion switch (door opening detection and/or removal from the
mounting position).
1.5 Battery Standby Times versus AUX Load
In accordance with EN50131-1 Standard, for a Power Supply
Type A rated for Grade 2 systems, the battery standby time
required in case of failure of the prime power source shall be a
minimum of 12 hours.
The table below indicates the maximum load values applicable to
the AUX+/-, Keybus (Red, Black) and PGM 1-4 outputs that the
panel (PC1616/PC1832/PC1864) will be able to support when
using a certain battery size for a certain period of time as applica-
ble for each installation.
The AUX +/-, Keybus (Red, Blk) and PGM 1-4 outputs are all
sharing the same load (max. 500mA), (max. 700mA for UL/ULC),
(max. 550mA for IMQ). Please refer to the other Power Series
accessories current ratings when calculating the maximum load
applicable for each installation.
Standard Battery Charging Current: 400mA (280mA for IMQ).To
be used with 4Ah or 7Ah batteries.
High Battery Charging Current: 700mA. To be used with 14Ah or
24Ah batteries.
NOTE:
Program Section [701] option 7 to ON to enable high bat-
tery charging current, if 14Ah or 24Ah battery is used.
Refer to the following table for UL/ULC Applications:
NOTE:
When two batteries are required in order to meet the min-
imum standby times, the DSC Enclosure Model Power UC1 shall be
used (for European Installations only).
NOTE: A sealed, rechargeable, lead acid battery or gel type bat-
tery is required to meet UL requirements for power standby times.
NOTE: UL Residential/Commercial Burglary installations require
4Hrs Power Standby time.
NOTE: UL/ULC Residential Fire & Home Health Care installations
require 24 Hr power standby. ULC Commercial Burglary and Fire
monitoring installations require 24 Hr power standby.
NOTE: Replace batteries every 3-5 years, battery capacity will
deteriorate with age and number of charge/discharge cycles.
Enclosure Description/Dimensions
PC500C Description: Alternate Main Control Cabinet (House-
hold Burglary).
Approximate Dimensions: 213mm x 235mm x 76mm /
8.4” x 9.25” x 3.0”
PC5002C Description: Cabinet to house the PC5204 Power Sup-
ply Output Module.
Approximate Dimensions: 213mm x 235mm x 76mm /
8.4” x 9.25” x 3.0”
PC5003C
(Removable
Door)
Description: Main Control Cabinet for the PC1616/
PC1832/PC1864 main panel with removable door. (UL/
ULC Household Fire & ULC Commercial Burglary) Made
with 22Ga steel.
Approximate Dimensions: 287mm x 297mm x 76mm /
11.3” x 11.7” x 3.0”
PC5003C
(Hinged Door)
Description: Main Control Cabinet for the PC1616/
PC1832/PC1864 main panel with removable door. Made
with 1.2mm thick steel.
Approximate Dimensions: 287mm x 297mm x 76mm /
11.3” x 11.7” x 3.0”
PC5004C Description: Cabinet to house the Escort5580(TC)
Module and PC5400 Printer Module.
Approximate Dimensions: 229mm x 178mm x 66mm /
9.0” x 7.0” x 2.6”
PC5001C Description: Cabinet to house the PC5108 Zone
Expander Module and the PC5208 Eight Low Current
Output Module.
Approximate Dimensions: 152mm x 122mm x 38mm /
6.0” x 4.8” x 1.5”
PC5001CP Description: Plastic Cabinet to house the PC5108 Zone
Expander Module and the PC5208 Eight Low Current
Output Module.
Approximate Dimensions: 146mm x 107mm x 25mm /
5.75” x 4.2” x 1.0”
PUC-1 Description: Main control cabinet for the PowerSeries
panel. Made with 18Ga steel.
Approximate Dimensions: 318mm x 318mm x 102mm
/ 12.5” x 12.5” x 4.0”
CMC-1 Description: Alternate Main Control Cabinet (UL Com-
mercial Burglary)
Approximate Dimensions: 287mm x 297mm x 76mm /
11.3” x 11.7” x 3.0”
Multi-3 Description: Cabinet to house the PC5937.
Approximate Dimensions: 287mm x 297mm x 76mm /
11.3” x 11.7” x 3.0”
HS-CAB1000 Description: Structured wiring cabinet for PC1616/
PC1832/PC1864 main panel, with a wire raceway in the
center of the cabinet.
Approximate Dimensions: 362mm x 362mm x 102mm
/ 14.25” x 14.25” x 4.0”
Approximate Dimensions of Cover: 389mm x 389mm
/ 15.3” x 15.3”.
HS-CAB3000 Description: Structured wiring cabinet for PC1616/
PC1832/PC1864 main panel, with a wire raceway in the
center of the cabinet.
Approximate Dimensions: 724mm x 362mm x 102mm
/ 28.5” x 14.25” x 4.0”
Approximate Dimensions of Cover: 752mm x 389mm
/ 29.6” x 15.3”.
HS-CAB4000 Description: Structured wiring cabinet for PC1616/
PC1832/PC1864 main panel, with a wire raceway in the
center of the cabinet.
Approximate Dimensions: 1086mm x 362mm x
102mm / 42.75” x 14.25” x 4.0”
PC4050C Description: Alternate Main Control Cabinet (UL/ULC
Household Fire & ULC Commercial Burglary) for the
PC1616/PC1832/PC1864 main panel.
Approximate Dimensions: 305mm x 376mm x 124mm
/ 12.0” x 14.8” x 4.9”
PC4050CR Description: Alternate Main Control Cabinet (ULC Com-
mercial Fire) for the PC1616/1832/1864 main panel.
Approximate Dimensions: 305mm x 376mm x 124mm
/ 12.0” x 14.8” x 4.9”
PC4050CAR Description: Alte
rnate Main Control Cabinet (UL Com-
mercial Burglary) for the PC1616/PC1832/PC1864 main
panel.
Approximate Dimensions: 305mm x 376mm x 124mm
/ 12.0” x 14.8” x 4.9”
Enclosure Description/Dimensions
PC4003C Description: Single expander cabinet made of 18Ga
steel, painted, hinged door, weight: 1050g.
Approximate Dimensions: 229mm x 178mm x 64mm /
9.0” x 7.0” x 2.5”
PC4051C Description: Cabinet made of 18Ga steel, painted,
hinged door, weight: 3600g.
Approximate Dimensions: 427mm x 264mm x 106mm
/ 16.8” x 10.4” x 4.18”
Battery
Capacity
Standby Times
4hrs 12hrs 24hrs 36hrs
4Ah 500mA 220mA - -
7Ah 500mA 480mA 150mA -
14Ah - 500mA 480mA 280mA
24Ah - - 500mA 500mA
Battery
Capacity
Standby Times (UL/ULC)
4hrs 24hrs
4Ah 700mA -
7Ah 700mA 180mA
14Ah (2x7Ah in parallel) 700mA 470mA
To Next Page
Loading...
