DSC PowerSeries PC1616 Installation Guide

PowerSeries - PC1616/PC1832/PC1864
46
[380] First Communicator Options
[381] Second Communicator Options
[382] Third Communicator Options
*This option must remain OFF for SIA CP-01 installations.
** A Call Waiting Cancel on a non-Call Waiting line will prevent successful connection to the central station.
[383] Fourth Communicator Options
[389] TL/GS Module Fault Check Timer
Default: 003 I_______I_______I_______I Enter no. of checks X 3 seconds - valid entries 002 to 255
Opt Def ON OFF
1
 J
Communications Enabled
J
Communications Disabled
2
J
Restorals on Bell Time-out
 J
Restorals Follow Zones
3
J
Pulse Dialing
 J
DTMF Dialing
4
J
Switch to Pulse Dialing on 5th Attempt
 J
DTMF Dial For All Attempts
5
J
3rd Telephone Number Enabled
 J
3rd Telephone Number Disabled
6
J
Alternate Dial (1st & 3rd)
 J
Call 1st Number, Back up to 3rd
7
J
For Future Use
 J
8
J
Delinquency Follows Zone Activity (Hours)
 J
Delinquency Follows Arming (Days)
Opt Def ON OFF
1
J
Open After Alarm Keypad Ringback Enabled
 J
Open After Alarm Keypad Ringback Disabled
2
J
Open After Alarm Bell Ringback Enabled
 J
Open After Alarm Bell Ringback Disabled
3
J
SIA Sends Programmed Reporting Codes
 J
SIA Sends Automatic Reporting Codes
4
J
Closing Confirmation Enabled
 J
Closing Confirmation Disabled
5
 J
Talk/Listen on Phone Lines 1/3
J
No Talk/Listen on Phone Lines 1/3
6
 J
Talk/Listen on Phone Line 2
J
No Talk/Listen on Phone Line 2
7
J
Contact ID Uses Programmed Reporting Codes
 J
Contact ID Uses Automatic Reporting Codes
8
J
ULC Communications Priority Enabled

J
ULC Communications Priority Disabled/Standard Priority
Followed
Opt Def ON OFF
1
J
For Future Use

J
2
J
Alarm Communications Enabled During Walk Test*

J
Alarm Communications Disabled During Walk Test
3
J
Communication Cancelled Message Enabled (ON for SIA CP-01)

J
Communication Cancelled Message Disabled
4
J
Call Waiting Cancel Enabled**

J
Call Waiting Cancel Disabled
5
J
T-Link Interface Enabled

J
T-Link Interface Disabled
6
J
AC Failure Transmission Delay is in Hours

J
AC Failure Transmission Delay is in Minutes
7
J
Number of Dialing Attempt for Residential Dial is 1

J
Residential Dial Follows Dialing Attempts Counter
8
J
For Future Use

J
Opt Def ON OFF
1
J
Account Code Follows Phone Number

J
Account Code Follows Partition
2-8
J
For Future Use

J

DSC PowerSeries PC1616 Specifications

General

Partitions	2
Keypads	Up to 8
Zones	6 on-board
PGMs	2
Power Supply	16.5VAC
Battery Backup	12VDC, 4Ah