The low beam lights are turned on the first time it is
pressed; from this moment, the same button can be
used to switch on (and off) the high beam light: if the
engine is not started within 60 seconds, the low
beam and high beam that were turned on will turn off.
If the headlight was turned on before starting the
engine with the procedure described above, the
headlight turns off automatically when starting the
vehicle and will turn on again when the engine has
been completely started.
Turn indicators
Turn indicator automatic reset is controlled by the
instrument panel.
After activating one of the two turn indicators, user
can reset them using the button (3, Fig 57) on the left
switch.
If the turn indicator is not reset manually, the
instrument panel will automatically switch it off after
the motorcycle has traveled 0.3 miles (500 m) from
when the turn indicator was activated. The counter
for the distance traveled for automatic deactivation is
only activated at speeds below 50 mph (80 km/h).
If the calculation of the distance for automatic
deactivation is activated and then the motorcycle
exceeds a speed of 50 mph (80 km/h), the calculation
is interrupted and will restart when the speed returns
below the indicated threshold.
104
To Next Page
Loading...
Need help?
General
