Clock setting function (CLOCK)
This Function allows setting time.
To view this function, enter the Setting Menu, use
button (1) or (2) to select "CLOCK" and press button
(4).
To access the setting function, keep button (2)
pressed for 3 seconds.
After 3 seconds, it is possible to set the time as
follows:
- the "AM" indication starts flashing;
- if you press button (2) the "PM" indication
starts flashing;
- if you press button (1) you will return to the
previous step (if time is 00:00, 12:00 will be
displayed when switching from "AM" to
"PM").
- Press button (4) to shift to hour setting, hours will
start flashing;
- each time you press button (2), the digit will
increase by one hour. If you hold button (2)
down, the number increases cyclically in
steps of one hour every second (when the
button is held depressed, the hours do not
flash).
- Press button (4) to shift to minute setting,
minutes will start flashing;
- each time you press button (2), the digit will
increase by one minute. If you hold button
(2) down, the number increases cyclically in
steps of one minute every second;
- if button (2) is kept depressed for more than
5 seconds, speed increases and digits
change in steps of 1 every 100 ms (when
button (2) is held depressed, seconds will
not flash).
84
To Next Page
Loading...
Need help?
General
