Instrument panel back-lighting setting
(B.LIGHT)
This function allows adjusting the backlighting
intensity.
To adjust the backlighting gain access to the SETTING
MENU, and keys (1) and (2) to select the "B.LIGHT"
indication, then press button (4) to confirm.
When accessing the function, the active mode will
flash whereas the MENU and EXIT texts will be
steady on.
Use buttons (1) and (2) to select the desired
brightness level (HIGH, MED, LOW) and press button
(4) to confirm.
Select HIGH to set the display backlighting maximum
brightness - recommended in conditions of strong
ambient light.
Select MED to set the display backlighting medium
brightness (70%) - recommended in conditions of
medium/low ambient light.
Select LOW to set the display backlighting minimum
brightness (50%) - recommended in conditions of low
ambient light and/or during the night.
After confirming, the "EXIT" box will start flashing.
To exit the menu and go back to previous page, select
"EXIT" and press button (4).
Note
In the event of an interruption of the power
supply from the Battery, when power is restored, at
the next Key-On, the backlighting will always be set
by default to maximum brightness.
82
To Next Page
Loading...
Need help?
General
