After pressing button (4) to confirm the fourth and last
figure, the 4-digit code starts flashing.
Press button (4) and the system will check the
entered PIN CODE. After you press the button:
- if the PIN CODE is correct (D), the instrument
panel shows "OK" flashing for 3 seconds,
followed by " N: " (new) followed by four flashing
dashes "- - - -" referred to the new PIN (F).
- if the PIN CODE is not correct (E), the instrument
panel shows "ERR." flashing for 3 seconds,
followed by " O: " (old) followed by four flashing
dashes "- - - -" to enter the PIN again .
Repeat the procedures until you confirm all the four
digits of the PIN CODE.
Entering the "new" code:
1) Press button (4), one digit starts flashing
indicating "0";
2) Each time you press the button (2) the displayed
number increases by one (+ 1) up to "9" and then
starts back from "0";
3) Each time you press the button (1) the displayed
number decreases by one (- 1) up to "1" and then
starts back from "0";
4) To confirm the number, press the button (4);
Repeat the procedures until you confirm all the four
digits of the PIN CODE.
93
To Next Page
Loading...
Need help?
General
