2
39
PC Controller Setting
PC Controller Setting
5
Function Setting
Air Knife
Compressed air is blown out to loosen the documents.
This is to prevent double feed.
Reg. Mark
Select whether to use REG. Mark function or not.
When using this function, enter the position of REG. Mark.
Side mark: 3.0 to 15.0 mm (From the right edge of the document)
Lead mark: 3.0 to 15.0 mm (From the top edge of the document)
Suction Power
This suctions the document to the conveyance belt for skew correction.
Slitter Guide
When any units of the modules are not used, these units act as document guide to stabilize
the document conveyance.
Select “Enable” or “Disable”.
Recommended for light weight document.
Auto Cut
Lead margin and trail margin are fi nely cut, and dropped into the waste box.
If a document has no lead margin or trail margin, select “Disable”.
Crease Depth
This sets the depth of the crease when creasing a document.
Speed
Select the processing speed.
Barcode
This sets whether to execute automatic setup when reading a barcode.
Double Feed Detection
This detects double feed (two or more sheets are fed at once).
To Next Page
Loading...
Need help?
General
