50
PC Controller Setting
PC Controller Setting
Length (Custom size)
When you want to use “Custom size” document, enter
the value of the document length in the [Length] box.
When you select “Standard size” in step 6, the selected
document length value appears here.
Side Mark
Enter the distance from the right edge of the document
to the side mark in the [Side Mark] box.
Enter “0” if you do not use the “Read REG. Mark”
function.
Lead Mark
Enter the distance from the lead edge of the document
to the lead mark in the [Lead Mark] box.
Enter “0” if you do not use the”Read REG. Mark”
function.
REFERENCE
Slit
When “Advanced Mode” is selected, the numbers 1 to 6
appear under “Slit”.
When “Simple Mode” is selected, the alphabets A to F
appear.
Click each [Slit] box, then enter the distance from the
right edge of the document to the slit position.
After entering the value, press the [Enter] key to set the
value.
Enter “0” when fi nishing the slit setting.
● Advanced Mode:
Slits are set in numerical order from Slit 1 to Slit 6.
● Simple Mode:
Slits are set in alphabetical order from Slit A to Slit F.
F E D C B A
2 4 6 5 3 1
Document feed direction
To Next Page
Loading...
Need help?
General
