Duplo DC-616 - Page 57

2
51
PC Controller Setting
PC Controller Setting
5
Cut
Click each [Cut] box, then enter the distance from the
lead edge of the document to the cut position.
Up to 25 cuts can be set.
Enter “0 when fi nishing the cut setting.
Crease
Click each [Crease] box, then enter the distance from
the lead edge of the document to the crease position.
Up to 20 creases can be set.
Enter “0” when fi nishing the crease setting.
REFERENCE
Check the JOB details.
When you want to change the details, click the item and
re-enter it.
Perforation
Click each [Perforation] box, then enter the distance
from the right edge of the document to the perforation
position.
After entering the value, press the [Enter] key to set the
value.
Move the perforation unit to the perforation position with
your hands.
The input here is only memorandum of the perforating
positions. For the details of changing the perforation tool
position and depth, refer to “Preparation Before Use” of
“Chapter 1 Before Using This Machine” in the “DC-616
Instruction Manual”.)