To Next Page

To Previous Page

PC Controller Setting

Apply Shrinkage

In case printed documents are shrunk by heat generated

on digital printer, by entering the original document

size and document size after shrunk, the DC-616

automatically calculates the shrinkage ratio and adjusts

the cutting and creasing position accordingly.

1. Select the [Apply Shrinkage] check box to enable

this function.

Then click [Adjust].

This function compensates for the shrinkage in the feed direction only.

2. Enter the document length before printing in the

[Original document length] box.

Enter the document length after printing in the [Actual

document length] box.

3. Click [OK].

Clicking [BACK] cancels the input value.

REFERENCE

2. Click the text box that you want to change the

processing position, then enter the value for shifting.

3. Click [OK].

Clicking [BACK] cancels the input value.

Adjust All

This function corrects the document position in vertical/

horizontal direction against the JOB set (mm).

1. Select the [Adjust all] check box to enable this

function.

Then click [Adjust].

1. Click [Correct position setting].

Duplo DC-616 Instruction Manual

Other manuals for Duplo DC-616