75
2
Messages
Troubleshooting
6
Display Countermeasure
This message appears when returning to the previous screen without
saving or downloading the JOB.
Clicking [OK] returns to the previous screen without saving the JOB.
Clicking [Cancel] enables you to save or download the JOB.
Finished product of less than 67.0 mm within the trail edge of 67.0 mm
is automatically cut fi nely and is dropped into the waste box.
Clicking [OK] ignores the message and proceeds with the next process.
(→P.36 “Limits of the Trail Cutting”)
REG mark reading speed decrease warning message
This message appears when retrieving a JOB, lead mark is 5.5 mm or
less and [REG. Mark] on the [SETTING] tab is set to “Fast”.
[REG. Mark] automatically turns to “Normal” (standard).
Clicking [OK] starts the JOB.
This message appears when the perforation unit is enabled and “3” or
larger number is entered in [Cards per Document].
Clicking [OK] returns to the setting screen. Re-enter the value.
This message appears when the position of perforation tools are
changed by changing a JOB with barcode reading function.
Move the perforation tools to the correct position.
Clicking [OK] clears the error.
This message appears when the perforation unit is enabled and a JOB
containing perforation process is retrieved, or [Start] button or [Test]
button is clicked with the perforation unit installed.
Check if the perforation tools are located at the set position in the JOB.
Clicking [OK] starts the JOB.
Clicking [Cancel] returns to the main menu screen.
This message appears when retrieving a JOB containing gutter slits and
clicking the [Start] button.
Lower the gutter defl ectors manually so that they can be used.
Clicking [OK] starts the JOB.
Clicking [Cancel] returns to the main menu screen.
This message appears when retrieving a JOB not containing gutter slits
and clicking the [Start] button.
Raise the gutter defl ectors manually so that they are not used.
Clicking [OK] starts the JOB.
Clicking [Cancel] returns to the main menu screen.
This message appears when the option unit is changed by changing a
JOB with barcode reading function.
Replace with the correct option unit and click [OK]. The error is cleared.
To Next Page
Loading...
