18
Before Using This Machine
Slit/Cut/Crease Limitations
The following describes limitations of slit/cut/crease process on the DC-618.
Document feed direction
Slit 2 Slit 6 Slit 4 Slit 3 Slit 5 Slit 1
Cut 1
Crease 1
Cut 2
Cut 3
Cut 4
Crease 2
Left margin:
3.2–55.0 mm
from the left
edge
Card width:
48.0 mm or more
Gutter:
5.0–15.0 mm
Right margin:
3.2–55.0 mm from
the right edge
Trail margin:
5.0 mm or
more
Center margin:
3.0 mm or more
(More margin
may be required
depending
on document
types.)
Card length:
50.0 mm or more
Lead margin:
3.0 mm or more
Slit:
The DC-618 can slit up to six positions on one document.
Slit 1 and Slit 2 are for cutting the margins on both side edges.
Cut:
The DC-618 can cut up to 30 positions on one document.
Crease:
The DC-618 can crease up to 20 positions on one document.
To Next Page
Loading...
