JOB Entry
53
2
Programming a JOB
Message Status and Solution
Gutter cut(s) will be output on the
exit tray
Status: The size(s) of gutter cut(s) is/are not proper to be
ejected to the waste box.
Solution: Re-enter a size(s) of the gutter cut(s).
Cannot position specifi ed number
of cards lengthwise
Status: The number of the fi nished products in a length
direction exceeds the limit.
The number of the card that can be entered is
displayed.
Solution: Re-enter values within the displayed number of
the cards that can be entered.
Number of creases exceeds the
spec
Status: The number of creases exceeds 20.
Solution: Re-enter the number of creases of 20 or less.
Crease is programmed outside
the fi nished product.
Status: A crease is programmed outside the fi nished
product.
Solution: Re-enter values for crease positions.
With Adjust All values, the last cut
is within 60mm from the trail edge.
The last card cannot be fi nished
and sent to the waste box.
Status: With the
Adjust All
values, the last cut is within 60.0
mm from the trail edge.
Solution: Re-enter values for
Adjust All
.
By clearing Adjust All values, the
last cut is within 60mm from the
trail edge. The last card cannot
be fi nished and sent to the waste
box.
Status: By clearing the
Adjust All
values, the last cut is
within 60.0 mm from the trail edge.
Solution: Re-enter values for
Adjust All
.
To Next Page
Loading...
Need help?
General
