69
2
Process
3
Basic Operations
REFERENCE
When having fi nished all the settings, touch
SET
.
The settings are saved and the
standby
screen
reappears.
IMPORTANT
2.
Trail Cut Mode
This sets whether dummy cut for the trail margin is processed or not.
Touch the / icon to select
AUTO
or
OFF
.
AUTO
: Performs dummy cut for the trail margin one time.
OFF
: Does not perform dummy cut.
Trail
margin
Document
feed
direction
Trail cut
• Dummy cut:
The DC-618 performs cutting operation without
a document to be cut at the position where
the document is fed for the distance of the trail
margin plus extra length.
This is effective for dropping a document, such
as when the trail margin is jammed between the
roller and the lower tool in the cutter section.
• Trail Margin:
This means margin of the trail edge of the
document produced when the last cut is
performed.
Cut
1.
Cut Trim Setting
The lead margin, the trail margin, and any gutter
cuts are chopped up and dropped into the waste
box.
Touch the / icon to select
Full Bleed Mode
,
No Bleed Mode
, or
Process All
.
Full Bleed Mode
: The lead margin and the trail margin are chopped up and dropped into the
waste box.
Any other gutter cuts shorter than 49.0 mm in width are also chopped up
and dropped into the waste box.
No Bleed Mode
: Gutter cuts shorter than 49.0 mm in width are chopped up and dropped
into the waste box. If a document is processed without either of the lead
margin or the trail margin, make sure to select
No Bleed Mode
.
Process All
: All of the cut pieces are ejected to the
exit tray
. Gutter cuts shorter than 30.0
mm in width are chopped up and dropped into the waste box. Trail margin
shorter than 60.0 mm are chopped up and dropped into the waste box.
Air Knife
,
Suction Power
,
Blow Fan
,
Slitter
Guide
,
Crease Depth
,
Cut Trim Setting
, and
Trail Cut Mode
are normally set when a JOB is
programmed. The settings with
Process
are valid
only for the process performed right after the
setting is made and are not saved in the JOB.
◄ ►
◄
►
To Next Page
Loading...
Need help?
General
