Duplo DC-645 - Page 62

61
1
3
Programing JOB for DC-645 on Control Panel
How to Program Job on Control Panel
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the right edge of the
document to the position for the SLIT 5.
This value must be between 58 and 212 mm.
Pressthe <SET> keywheninputiscompleted.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the right edge of the
document to the position for the SLIT 6.
The value must be (the value entered for SLIT 5
+ 48 mm) or more.
Pressthe <SET>keywheninputiscompleted.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
document to the position for CUT 1.
This value must be smaller than the value set
for paper length.
Pressthe <SET>keywheninputiscompleted.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
document to the position for CUT 2. This value
must be bigger than the value set for CUT 1 and
smaller than the value set for paper length.
If CUT 2 is not required, enter 0. When there is
only 1 cut on document, AUTO CUT function
must be turned off.
Press the <SET>key when input is completed.
Hereafter, check the number value input, to similarly set to
CUT 15.
SLIT 5 60.0mm
(
0,58.0–212.0
)
SLIT 6 210.0mm
(
0,108.0–212.0
)
CUT01 10.0mm
(
0–460.0
)
CUT02 190.0mm
(
0,95.0–460.0
)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the right edge of the
document to the position for the SLIT 4.
The value must be (the value entered for SLIT 3
+ 48 mm) or more.
Pressthe <SET> keywheninputiscompleted.
SLIT 4 160.0mm
(
0,158.0–212.0
)
Continue Page •••