Duplo DC-645 - Page 63

62
How to Program Job on Control Panel
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
(The display on the right will only appear when
the Optional Module in Step 8 is set to
“BUSINESS” (Business Card Module)).
Input the distance of the optional module
processing position from the right edge of the
document to the processing position.
Press the <SET>key when input is completed.
OPTION1 5.0mm
(
4.0–10.0
)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and turn ON/OFF the compressed air blowout
at the feed area to loosen the documents.
Press the <SET>key when the setting is set.
Tip
• Turnonthisfunctionwhenprocessing
documentswithexcessivestaticelectricityor
heavyweightdocuments.
AIR KNIFE ON
∗
OFF
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and turn ON/OFF the fan function.
When this is ON, the performance of the
document skew condition is improved.
Press the <SET>key when the setting is set.
Tip
• Whenthedocumentweightislight,thismay
causepaperjam.Therefore,keepturnedOFF.
FAN REG.
∗
ON
OFF
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Enter the distance from the leading edge of the
document to position for the first crease.
A number value within the length of the paper
length set can be input.
Pressthe <SET>keywheninputiscompleted.
Hereafter,checkthenumbervalueinput,tosimilarlysetto
CRE10.
CRE.01 100.0mm
(
0–460.0
)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and turn ON/OFF REG. Mark reading for
image drift compensation.
Press the <SET>key when the setting is set.
REG.MARK ON
∗
OFF
IMPORTANT
• It is not possible to turn ON the REG. mark
(Function Mode) if either the Lead Mark or
Side Mark doesn’t have a number entry (i.e. if
the number entry is 0mm). Please enter a
number to turn ON the REG mark function.