Duplo DC-645 - Chapter 4: Basic Operations; Processing Documents by Selecting JOB

63
1
3
Programing JOB for DC-645 on Control Panel
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch the
creasing depth between and set MAX, Mid or
MIN.
The crease will be deep when MAX is set and
will be shallow when MIN is set.
Pressthe <SET>keywheninputiscompleted.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the <SET> key to retain the settings or
<C> key to cancel the settings.
[MEMORY !!] is displayed when the JOB is
saved on the DC-645 memory circuit.
The memorization process will take approximately 1.5
seconds.
CREASE DEPTH
MAX
∗
MID MIN
OVER WRITE ?
OK
( )
NO
(
C
)
MEMORY !!
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and turn ON/OFF.
Pressthe <SET>keywheninputiscompleted.
AUTO CUT
∗
ON
OFF
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and set High or Low processing speed.
Set to LOW for better processing precision.
Pressthe <SET>keywheninputiscompleted.
SPEED
∗
HIGH
LOW
How to Program Job on Control Panel
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Use the <+> key and <–> key to switch between
and turn ON/OFF the Slit Guide function.
When this function is ON, the unused slitter
acts as a paper transport guide.
Press the <SET>key when the setting is set.
Tip
• TurnONonlywhenthedocumentweightislight.
SLIT GUIDE ON
∗
OFF