EasyManua.ls Logo

DURAVIT Pool - Initial Pool Setup; Charging the Remote Control; Filter Preparation and Installation

DURAVIT Pool
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
4.10 Tub covers
When the pool is not in use, use pool covers to reduce the pool's energy consumption
and evaporation of the water.
4.11 Tarpaulin
We recommend the use of a tarpaulin when the pool is not in use. This protects the pool
against dirt and damage. Only use the tarpaulin if you have also fitted the pool covers.
5. First Start-up of the Pool
Carry out each of these steps individually in order to start-up the pool correctly and
as quickly as possible. The diagrams referred to are collected together in the chapter
Diagrams and Pictures.
Step 1: Charge remote control
> Place the remote control on the charging station.
The
Emotion button blinks, when the battery is being charged.
When the battery is fully charged the
Emotion button will be permanently illumi-
nated.
Step 2: Prepare filter
> Remove the acrylic/wooden liner (6 - Blue Moon) and/or the padded cover (Sun-
deck).
> Remove the white cover located over the fine filter (5).
> Pull the tab upwards and turn the screw of the fine filter (5)in an anti-clockwise
direction (Fig. 1) and remove. (Fig. 2)
> Remove the cover completely. (Fig. 3)
> Remove the exchangeable cartridge from its packing and place it in the fine filter
(5). (Fig. 4)
> Close the fine filter (5) again.

Table of Contents