42
> Press out the white plastic valve from the inside out with a blunt object. (Fig. 7)
> Carefully insert a new plastic valve from the outside.
> Insert a new exchangeable cartridge (order no. 790598 00 0 00 0000).
> Close the fine filter (5) again.
> Press the
“Hygiene” button on the operator's panel.
The
“Hygiene” button lights up, the hygiene and temperature circuit starts.
Fig. 6 Fig. 7
11.7 Add tap water
NOTICE
Damage to health and the pool due to increased drinking water limits.
> Observe the drinking water limits in accordance with the drinking water regulations
(TrinkwV 2001).
Chloride 250 mg/l
Iron 0.2 mg/l
Sodium 200 mg/l
Sulphate 250 mg/l
Tritium 100 Bq/l
Calcium 48 mg/l
Calcium carbonate 120 mg/l
Electrical conductivity 2790 µS/cm at 25 °C
Oxidation ability 5 mg/l O
2
> Fill the pool with tap-water (water temperature <40 °C; water hardness 1-1.5 mmol/l
(5.6-8.4°dH)) until the water level is about 50 mm above the uppermost jet.
To Next Page
Loading...