26
again. As soon as the remote control is in radio range, the house symbol appears
on the operator's panel display.
What if the remote control still does not respond?
> For further causes, see chapter
“Help in Case of Problems”.
7.8 Start integrated filling (optional)
> Press the “OK” button to access the menu.
> Select Settings > Water > Fill.
> Press the
“OK” button.
The pool will start filling and a check mark appears next to Filling.
The filling will stop automatically as soon as the pool is filled.
7. 9 Empty pool
> Press the “OK” button to access the menu.
> Select Settings > Water > Empty.
> Press the
“OK” button.
The pool will start to empty and a check mark appears next to Emptying. When the
pool is completely empty, the blowing procedure begins after about five minutes.
> Wait until the blowing process is finished (about two minutes) and an additional five
minutes until the drain closes automatically.
“Emptying in Process” message will go out on the operator's panel.
> Make sure the pool is switched off at the mains socket/switch.
8. Change Settings
8.1 Change / activate / deactivate PIN
The Settings menu and the ECO/Standby-mode can be protected by activating the PIN
function. If you do not want to do this, you can deactivate it by selecting
“0000” as the
PIN.
> Press the
“OK” button to access the menu.
> Select Settings > Change PIN.
“PIN-request” is displayed on the operator's panel
To Next Page
Loading...