DURAVIT Pool - Remote Control Charging

25
To alter the brightness
> Press the
“-” or “+” button in order to alter the brightness of the six coloured and the
white lights. The lighting strength decreases or increases.
To alter the speed of the colour change or the pulsing
Prerequisite: Colour programme 1, 2 or 5 is activated. The speed or the pulsing can
only be altered for these colour programmes.
> Press the
“-” or “+” buttons.
7. 6 Sound (optional)
Prerequisite: Bluetooth capable audio source with protocol A2DP.
> Press the “OK” button to access the menu.
> Select Sound.
Bluetooth mode is activated.
> Activate the Bluetooth mode on your audio source as described in its operating
instructions.
> Search for the
“Duravit” Bluetooth device and establish a connection to it.
> Enter the activation code:
“2412”.
> Select music and adjust the volume on your audio source.
7.7 Charge remote control
> Place the remote control on the charging station.
The
“Emotion” button blinks, when the battery is being charged.
When the battery is fully charged the
“Emotion” button will be permanently illumi-
nated.
Keep the remote control on the charging station when not in use. This will help keep
the remote control charged.
What if the remote control does not respond?
If the remote control is located out of radio range, it reverts to the energy saver
mode in order to extend the life of the battery. The remote control must then be
reactivated:
> Place the remote control on the charging station.
After 2 seconds, the
“Emotion” button lights up. The remote control is now active