DURAVIT Pool - Power Circuit Operation; Whirl Programme Activation

23
To change intensity
> Press the
“-” or “+” buttons until the desired intensity of the water stream is set.
7.3 Power circuit
To switch on, change the steam setting or to switch off
> Press the
“Power” button.
Water stream is activated.
> Press the
“Power” button a second time.
Air / water stream is activated.
> Press the
“Power” button a third time.
Timed air / water stream is activated.
> Press the
“Power” button a fourth time.
The powercircuit will be switched off.
If the batteries in the remote control are empty or you can't find it? The Power cir-
cuit can be turned on or off at the operator's panel:
> Press the
“OK” button to access the menu.
> Select Power.
Massage with air/water stream can be switched on or off.
To change intensity
The intensity can only be changed with Power jets (not with Roto or Midi jets).
NOTICE
Damage to the unit due to closed Power jets.
> At least one jet must always be left open.
> Turn the jet inserts on, turn the Power jets to the left to increase the intensity, and
to the right to reduce the intensity.
7. 4 Whirl programmes
To switch on
> Press the required programme button
“1-5” twice.
The whirl programme will be switched on.