29
“Time h” is displayed on the operator's panel.
> Press the
“Off” or “On” button until the required hour is displayed.
> Press the
“OK” button.
“Time m” is displayed on the operator's panel.
> Press the
“Off” or “On” button until the minute required is displayed.
> Press the
“OK” button.
The time is changed and you are returned to the Settings sub-menu.
You have changed the time and now “Check heater” is displayed on the control panel?
> Disconnect the pool from power for 3 min.
8.6 Change units
> Press the “OK” button to access the menu.
> Select Settings > Units.
> Press the
“Off” or “On” button until the units required is displayed.
> Press the
“OK” button.
The units is changed and you are returned to the Settings sub-menu.
8.7 Reset settings
> Press the “OK” button to access the menu.
> Select Settings > Default (Default settings).
“Default” is displayed on the operator's panel.
> Press the
“OK” button.
All the settings for the pool are reset to their factory defaults and the pool must be
configured again from the start (see chapter
“First Start-up of the Pool”).
9. Shutting Down the Pool
If you are not going to use the pool for days, weeks or months at a time, there are dif-
ferent pool modes to cater optimally for energy consumption.
If the pool is disconnected from the power supply for a longer period, the time must
be reset.
To Next Page