DURAVIT Pool - Dirt-Absorbing Sponge; Coarse Filter Insert; Fine Filter

33
using the wrong detergents!
> Never use abrasive, aggressive or chemical cleaners.
10.1 Dirt-absorbing sponge
The dirt-absorbing sponge gathers 40 times its own weight in oils and reduces the
load on the filter system.
> Allow the dirt-absorbing sponge to float on the surface of the water.
> Wash the sponge regularly.
> Replace the sponge at least once a year (Order no. 7900951).
10.2 Coarse filter insert
NOTICE
Damage to the pump due to the incorrect setting of the hygiene
and temperature circuit!
> Stop the hygiene and temperature circuit to clean the coarse filter insert.
Clean the coarse filter insert after every bath, but at least once every 1-2 weeks:
> Press the
“Hygiene” button on the operator's panel to stop the hygiene and tempera-
ture circuit (starts again automatically after one hour).
The
“Hygiene” button flashes.
> Remove the cover of the suction outlet (3) located in the centre of the bath.
> Remove the cylindrical coarse filter insert plus any dirt.
> Remove the dirt and any visible particles.
> Clean the coarse filter insert, replace it and then replace the suction outlet cover.(3).
> Press the
“Hygiene” button on the operator's panel.
The
“Hygiene” button will light up, and the hygiene and temperature circuit will
start.
10.3 Fine filter
Clean out the fine filter housing and the filter cartridge weekly.
The diagrams referred to are collected together in the chapter
“Diagrams and Pictures”.
> Press the
“Hygiene” button on the operator's panel to stop the hygiene and tempera-