32
ensure the switch is not activated until you are ready to proceed.
> Open the fine filter (5).
> Remove the exchangeable cartridge and dispose of it (microbial contamination!)
> Open the bypass valve at the bottom of the fine filter with the tool supplied, so that
the hygiene and temperature circuit can run empty. (Fig. 5)
> Wait until the water has drained off.
> Close the bypass valve again.
> Clean the air valves in the cover of the fine filter housing under running water.
> Check the operation of the air valves.
> Clean out the fine filter housing with a damp cloth and re-close it (without a new
cartridge).
> Clean the coarse filter insert (3).
> Place the bath cushions around the pool and collapse the relaxing deck.
> Pull the tarpaulin over the pool and the cushions/relaxing deck.
Fig. 5
Start up pool again
Follow steps 1-2 and 4-5 as described in the chapter
“First Start-up of the Pool”. The
operator's panel does not need to be configured again from the start.
10. Cleaning and Maintenance
CAUTION
Detergents can unknowingly affect the hygiene balance of the water.
> Please ensure that detergents do not end up in the pool bathing water.
NOTICE
Damage can occure to the surfaces and the whirl system due to
To Next Page
Loading...