DURAVIT Pool - Medium Shutdown (2-4 Weeks); Long-Term Shutdown (Months)

31
Select from the menu.
Select ECO and/or ECO timer.
The
“ECO” button goes out and the water is warmed to bathing temperature.
> Check and adjust the water quality without fail before each use of the pool as this
can easily have deteriorated during the weeks that the pool was not in use.
9.2 Duration of shut down: 2-4 weeks
Standby-mode: The water temperature is reduced to the Standby-mode temperature.
Activate Standby-mode
DANGER
Potential health risk due to insufficient care of the water!
> Monitor the water quality during Standby-mode as well.
> Press the
“ECO” button.
> Select Standby.
The
“ECO” button is illuminated, Standby-mode is activated. “Standby” is displayed on
the operator's panel, together with the temperature.
> Allow the dirt-absorbing sponge provided and the floating sheet to float on the sur-
face of the water.
> Place the bath cushions around the pool and collapse the relaxing deck.
> Pull the tarpaulin over the pool and the cushions/relaxing deck.
Deactivate Standby-mode
At least 8 hours before you want to bathe!
> Press the
“ECO” button.
> Select Standby.
The
“ECO” button goes out and the water is warmed to bathing temperature.
> Check and adjust the water quality without fail before each use of the pool as this
can easily have deteriorated during the weeks that the pool was not in use.
9.3 Duration of shut down: A number of months
The diagrams referred to are collected together in the chapter “Diagrams and Pictures”.
> Empty the pool (see
“Empty pool” in the chapter “Operation”).
> Switch off the pool at the mains switch and remove the plug from the socket and