DURAVIT Pool - Changing the Language; Changing the Time

28
the following:
• The time ofloop 1 must be before the time ofcycle 2.
• There must be at least 8 hours difference between the times ofloop 1 and 2.
Example:
• Time ofloop 1 = 07:00
• Time ofloop 2 = 16:00
• Time of loop 1 takes place before time of loop 2.
There is a 9 hour difference (>8 hours) between loops 1 and 2.
> Press the
“OK” button to access the menu.
> Select Settings > Water > Water Changing.
“Loop 1” is displayed on the operator's panel
> Press the
“Off” or “On” button in order to set theloop 1 time.
> Press the
“OK” button.
“Loop 2” is displayed on the operator's panel
> Press the
“Off” or “On” button in order to set theloop 2 time.
> Press the
“OK” button.
The loop times have been changed and you are now in the Water sub-menu.
8.4 Changing the language
> Press the “OK” button to access the menu.
> Select Settings > Language.
> Press the
“Off” button until the required language is marked.
> Press the
“OK” button.
The language is activated and you are returned to the Settings sub-menu.
If you have selected the wrong language and you can't navigate to the Language menu?
> Press
“Off” and “OK” simultaneously.
You are now in the Language menu.
> Select the desired language.
> Press the
“OK” button.
The desired language is activated.
8.5 Changing the time
> Press the “OK” button to access the menu.
> Select Settings > Time.