EasyManua.ls Logo

DURAVIT Pool - Pool Cleaning Procedures

DURAVIT Pool
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
Water Level Too Low goes out on the operator's panel.
11.8 Clean pool
CAUTION
Chlorine bleach irritates the skin.
> Avoid contact with other chemicals and store separately.
> Observe the safety instructions on the disinfectant label.
> Do NOT bathe in the pool while disinfecting it.
> Empty and refill the pool when finished.
The diagrams referred to are collected together in the chapter
Diagrams and Pictures.
> Ensure that the room is well-ventilated during the disinfection process.
> Empty the pool (see
Empty pool in the chapter Operation).
> Spray a stream of water into the whirl circuit jets in order to rinse them.
> Wait until the message
Emptying in process goes out on the operator's panel.
> Fill the Pool with tap-water (water temperature <40 °C; water hardness of
1-1.5 mmol/l) until the water level is about 50 mm above the uppermost jet.
> Wait until the pool is completely filled. When it is completely filled the water chang-
ing cycle starts for one minute.
Water change active appears on the operator's panel.
> Wait for 3 minutes until the hygiene and temperaturecircuit starts automatically.
The
Hygiene button lights up.
> Open the air bleed valve (4) until water escapes then close it immediately.
> Add the chlorine bleach to the water in accordance with the manufacturer's instruc-
tions.
> Activate all whirlcircuits (duration according to instructions on the package insert).
> Empty the pool again.
> Spray a stream of water into the jets of the whirl circuits in order to rinse the disin-
fectant from the pipes.
> Wait until the message
Emptying in process goes out on the operator's panel.
> Replace the fine filter (5) (see Replacing the filter in the chapter
Water treatment).
> Clean the coarse filter insert (3).
> Fill the pool with tap-water (water temperature <40 °C; water hardness of
1-1.5 mmol/l (5.6-8.4°dH)) until the water level is about 50 mm above the upper-
most jet.
> Wait until the pool is completely filled. When it is completely filled the water chang-
ing cycle starts for one minute.

Table of Contents