EasyManua.ls Logo

DURAVIT Pool - Short Shutdown (2 Days - 2 Weeks)

DURAVIT Pool
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
> For this, refer to the chapter “Initial start of the pool” under Step 3 the item “To set
the time
”.
9.1 Duration of shut down: 2 days – 2 weeks
ECO-mode: Water temperature is lowered by 2 °C.
Activate ECO-mode
DANGER
Potential health risk due to insufficient care of the water!
> Monitor the water quality during ECO-mode as well.
... without timer
> Press the
“ECO” button.
Select from the menu.
> Select ECO.
The
“ECO” button is illuminated, ECO-mode is activated. “ECO” is displayed on the
operator's panel.
> Allow the dirt-absorbing sponge and floating sheet to float on the surface of the water.
> Place the bath cushions around the pool and collapse the relaxing deck.
> Pull the tarpaulin over the pool and the cushions/relaxing deck.
... with timer
The ECO timer can only be switched on for the next 24 hours.
> Press the
“ECO” button.
> Select ECO timer.
“Turn on-time” is displayed on the operator's panel.
> Press the
“Off” or “On” button until the required time is displayed.
> Press the
“OK” button.
The
“ECO” button flashes, the ECO timer is activated. The message “ECO” appears on
the operator's panel with the turn on-time of the bathing mode.
> Allow the dirt-absorbing sponge and floating sheet to float on the surface of the water.
> Place the bath cushions around the pool and collapse the relaxing deck.
> Pull the tarpaulin over the pool and the cushions/relaxing deck.
Deactivate ECO-mode
At least one to two hours before you want to bathe!
> Press the
“ECO” button.

Table of Contents