–
Loosen screws 12.
–
Align feed-dog support 13 in such a way that the feed-dog 14 in the
throat plate has an equal lateral clearance.
In longitudinal direction it should stand approximately in the center.
–
Tighten screws at the left shaft support 8 of the gear linkage.
–
Tighten screw 12.
ATTENTION: Danger of breakage !
The shaft 9 must not project from the shaft support 8 of the gear
linkage.
If this is the case, the whole gear has to be shifted to the right.
12
13 12
14
98
To Next Page
Loading...
