2. Sewing machine
2.1 Position of the arm shaft crank on the arm shaft
Caution: Danger of injury !
Switch off main switch.
Check and set the position of the arm shaft crank only when the
machine is switched off.
Standard checking
The arm shaft crank 1 is fastened on the arm shaft 4 with the three
screws 2. The screws must sit on the flat spot 3.
Correction
–
Loosen screws 2 at the arm shaft crank.
–
Twist arm shaft crank 1 on the shaft in such a way that
the screws 2 sit on the flat spot 3.
–
Push arm shaft c rank 1 axially to the right as far as it will go.
–
Tighten screws 2.
5
GB
21
1
2
3
4
To Next Page
Loading...
