2.9 Setting the short-trimming
The short-trimming can be switched off/on through the parameter 136.
Switched on is the standard factory-setting for any class. The lower
and upper thread should have approximately the same length after the
trimming. The length of the last stitch before thread trimming is
adjustable.
Setting the stitch length of the last stitch
–
Put the Allen key 1 in the Allen screw 3 through the hole 2.
–
To shorten the last stiitch, turn the screw 3 clockwise.
–
To lengthen the last stitch, turn the screw 3 counterclockwise.
Hint:
The stitch length of the last stitch cannot be greater than the stitch
length set.
29
GB
3
1
2
To Next Page
Loading...
