DURKOPP ADLER 367 - Feeding Foot and Presser Foot; Stroke of Feeding Foot and Presser Foot

2.7 Feeding foot and presser foot
2.7.1 Stroke of feeding foot and presser foot
Caution: Danger of injury !
Switch off main switch.
Check and adjust stroke only when the sewing machine is switched off.
Standard checking
The strokes of both feet should be equally high when the sewing foot
stroke is set to position “3”.
–
Set stitch regulator lever and stitch length setting wheel
respectively to “0”.
–
Set medium sewing foot pressure.
–
Set sewing foot stroke lever 1 to position “ 3”(on 367-170115 and
367-180115) or both s etting wheels 3 to position “3”(on
367-170315 and 367-180315).
–
Turn handwheel and compare the strokes.
The strokes of the feeding foot and the presser foot should be
equally high.
Correction
–
Turn handwheel.
The foot with the higher stroke should be slightly lifted.
–
Loosen screws 2.
On the class 367-170315 and 367-180315, do not take the cover
off the housing.
The screws 2 can be reached through the hole 4 after removing the
blanking plug.
If the presser foot had been lifted, it is lowered by the spring.
If the feeding foot had been lifted, it has to be pressed downward
by hand.
–
Tighten screws 2 again.
–
Check whether both strokes are equally high.
If this is not the case, correct the adjustment.
23
GB
1
2
43