20
Correction of the looping stroke position
–
Loosen screws at the toothed wheel 5.
–
Arrest machine head with locking peg Ø 5 mm in Position I (large
groove).
–
Set stitch regulator lever and stitch length setting wheel
respectively to “0”.
–
Turn hook in such a way that the hook tip 6 is at the level of the
middle of the needle.
–
Tighten screws at the toothed wheel 5.
–
Mount the dismanteld parts together (cf. chapter 2.6)
ATTENTION: Danger of breakage !
The toothed wheel must not abut on the bearing bush.
Shift toothed wheel away from the bearing bush a little bit.
5
6
To Next Page
Loading...
