9. Switching on - Switching off - Threading mode
9.1 Switching on
–
Switchthemainswitch1on.
The machine moves to the loading position and is ready for sewing.
9.2 Switching off
–
Switchthemainswitch1off.
All drives and the control are immediately separated from the
electric supply lines.
Attention!
The main switch is also the emergency stop button! When the main
switch is turned off, the machine is separated from the power supply!
9.3 Threading mode
Attention!
The “threading mode” must only be used for the operations necessary
for threading the needle thread, the looper thread and the gimp thread!
For all further operations (e.g. change of knife or cutting block) the
machine has to be switched off with the main switch!
Sw itching on the “Threading mode”
–
Press key 2 in the front plate. The key must snap in!
The sewing automat is in the ” Threading mode".
The key is shining in the “Threading mode”.
The fabric support plate moves to the best position for threading.
The fabric clamps remain in the same position as they were when
switching on the “Threading mode”.
Thesewingdriveisseparatedfromthemains.
The knife for cutting open is switched off.
Sw itching off the “Threading mode”
–
Press key 2 again. The key must be released.
After a short stop the sewing automat is ready for sewing again. The
sewing operation is continued where the ”Threading mode" had been
activated.
1
19
1
2
To Next Page
Loading...
Need help?
General
